• From: Berlin
  • Registered: 2008-07-08
  • Posts: 292

Topic: please make a Music Technology section

...for us gear junkies. we need a support group who will help feed our addictions.

*starts convulsing from withdrawal symptoms*

http://sneak-thief.com - raw electrofunk

sneakthief's Website

2 Reply by no-fi (edited by no-fi 2008-07-08 10:26:54)

  • From: the centre of the universe
  • Registered: 2008-07-08
  • Posts: 377

Re: please make a Music Technology section

actually - I have a gear question for you...
you built a GSSL, right?

I've just finished the main rev 7 boardset, minus a few parts I need to get and the switches which need to go in... and am getting ready to set it up and test it... anyway - I notice that if I solder the switches into the PCB, then the switch direction alignment is going to be a bit funny... compared to the cases I've seen online. Now I'm not about to buy any pre screened cases, and I don't think I can bring myself to solder the switches off-board..... so I'm probably just going to end up soldering them into the board anyway and deal with the odd switch direction positioning... but always keen to hear what other people have done.
:-)

no-fi's Website

  • cloud9
  • midnight robot
  • Offline
  • From: westcoast usa
  • Registered: 2008-07-07
  • Posts: 1,217

Re: please make a Music Technology section

Oh yes i can't wait for the gear section! I'm just starting up my room studio, getting a MS-20 in the mail anyday now and cannot wait! The synthslacker topics will def have to be put up again!

  • From: chroot
  • Registered: 2008-07-07
  • Posts: 680

Re: please make a Music Technology section

cloud9: an MS-20 in the mailbox? you have to have a big one then big_smile